Ip Access-Group - NETGEAR GSM7228PS Cli Manual

keyword ' ' to indicate a match on any value in that field. The remaining command parameters
any
are all optional, but the most frequently used parameters appear in the same relative order as
shown in the command format.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the number
of user configurable queues available for the hardware platform. The assign-queue parameter
is valid only for a permit rule.
Format
{deny | permit} {every | {{icmp | igmp | ip | tcp | udp | <number>}
<srcip> <srcmask>[{eq {<portkey> | <0-65535>} <dstip> <dstmask> [{eq
{<portkey>| <0-65535>}] [precedence <precedence> | tos <tos> <tosmask>
| dscp <dscp>] [log] [assign-queue <queue-id>] [{mirror | redirect}
<unit/slot/port>]
Mode Ipv4-Access-List Config

ip access-group

This command either attaches a specific IP ACL identified by <accesslistnumber> to an
interface or associates with a VLAN ID in a given direction. The parameter <name> is the name
of the Access Control List.
An optional sequence number may be specified to indicate the order of this IP access list relative to
other IP access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction, the
specified access list replaces the currently attached IP access list using that sequence number. If
the sequence number is not specified for this command, a sequence number that is one greater than
the highest sequence number currently in use for this interface and direction is used.
Note: You should be aware that the <out> option may or may not be available,
depending on the platform.
Default none
Format
ip access-group <accesslistnumber> <name> [vlan <vlan-id>] <in |
out>[sequence <1-4294967295>]
Modes • Interface Config
• Global Config
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
8-41