Redistribute (Ospf); Maximum-Paths (Ospf) - NETGEAR GSM7228PS Cli Manual

redistribute (OSPF)

This command configures OSPF protocol to allow redistribution of routes from the specified
source protocol/routers.
Default • metric—unspecified
• type—2
• tag—0
Format
redistribute {rip | static | connected} [metric <0-16777214>] [metric-
type {1 | 2}] [tag <0-4294967295>] [subnets]
Mode Router OSPF Config
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the specified
source protocol/routers.
Format
no redistribute {rip | static | connected} [metric] [metric-type]
[tag] [subnets]
Mode Router OSPF Config

maximum-paths (OSPF)

This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform dependent.
Default 4
Format
maximum-paths <maxpaths>
Mode Router OSPF Config
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its
default value.
Format
no maximum-paths
Mode Router OSPF Config
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-61