External-Lsdb-Limit (Ospfv); Maximum-Paths (Ospfv) - NETGEAR GSM7228PS Cli Manual

external-lsdb-limit (OSPFv3)
This command configures the external LSDB limit for OSPF.
limit. When the number of non-default AS-external-LSAs in a router's link-state database reaches
the external LSDB limit, the router enters overflow state. The router never holds more than the
external LSDB limit non-default AS-external-LSAs in it database. The external LSDB limit
MUST be set identically in all routers attached to the OSPF backbone and/or any regular OSPF
area. The range for <limit> is –1 to 2147483647.
Default -1
Format
external-lsdb-limit
Mode Router OSPFv3 Config
no external-lsdb-limit
This command configures the default external LSDB limit for OSPF.
Format
no external-lsdb-limit
Mode Router OSPFv3 Config
maximum-paths (OSPFv3)
This command sets the number of paths that OSPF can report for a given destination where
maxpaths is platform dependent.
Default 4
Format
maximum-paths <maxpaths>
Mode Router OSPFv3 Config
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its
default value.
Format
no maximum-paths
Mode Router OSPFv3 Config
IPv6 Commands
Managed Switch CLI Manual, Release 8.0.3
< >
limit
v1.0, July 2010
If the value is –1, then there is no
7-50