Enable (Ospf); No Enable (Ospf); Enable (Rip); No Enable (Rip) - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Format
Mode

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
Default
Format
Mode

no enable (OSPF)

This command sets the administrative mode of OSPF in the router to inactive.
Format
Mode

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
Default
Format
Mode

no enable (RIP)

This command sets the administrative mode of RIP in the router to inactive.
Format
Mode

distance ospf

This command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF can be intra, inter, type-1,
or type-2. The OSPF specification (RFC 2328) requires that preferences must be given to the
routes learned via OSPF in the following order: intra < inter < type-1 < type-2.
9-16
no default-metric
Router RIP Config
Enabled
enable
Router OSPF Config
no enable
Router OSPF Config
Enabled
enable
Router RIP Config
no enable
Router RIP Config
202-10009-01_060204
Routing Commands