Igmp Snooping Configuration Commands; Show Arp Access-List; Set Igmp - NETGEAR GSM7228PS Cli Manual

0/2

show arp access-list

Use this command to display the configured ARP ACLs with the rules. Giving an ARP ACL name
as the argument will display on ly the rules in that ARP ACL.
Format
show arp access-list [acl-name]
Mode • Privileged EXEC
• User EXEC
Example: The following shows example CLI display output for the command.
(Switch) #show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08

IGMP Snooping Configuration Commands

This section describes the commands you use to configure IGMP snooping. The software supports
IGMP Versions 1, 2, and 3. The IGMP snooping feature can help conserve bandwidth because it
allows the switch to forward IP multicast traffic only to connected hosts that request multicast
traffic. IGMPv3 adds source filtering capabilities to IGMP versions 1 and 2.

set igmp

This command enables IGMP Snooping on the system (Global Config Mode) or an interface
(Interface Config Mode). This command also enables IGMP snooping on a particular VLAN
(VLAN Config Mode) and can enable IGMP snooping on all interfaces participating in a VLAN.
Switching Commands
Untrusted
v1.0, July 2010
Managed Switch CLI Manual, Release 8.0.3
10 10
3-139