Set Ptse Refresh Interval - 3Com CoreBuilder 7000 Management Manual

Set PTSE Refresh
Interval
Sets the PTSE refresh interval value. The PTSE refresh interval is the
amount of time (in seconds) that passes before the next PTSE is flooded
to all the nodes in the current peer group. A change to the PTSE refresh
interval value takes place after the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
interval
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 4 5 1500
The following message is displayed:
Default Value is 1800, new value is 1500
Press ENTER to continue...
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(5) PRI: PTSE Refresh Interval
Format or Range
1 - 60000 seconds
1 1 10 4 3 4 5 [parameters]
The Hello inactivity factor is displayed and is updated
to its new value.
Default value is <x>, new value is <y>
Setting the Timers 401