Edge Center P - Omron Z550 Operation Manual

SECTION 3
Setting Measurement Conditions (Expert Menu)
Edge Center
The center position between two edges can be measured.
The following conditions will be used as an example for describing the setting procedures.
1.
Select [Meas set].
A list of outputs appears.
2.
Select an output for which [Edge center] is set.
In this example, select [OUT1].
The selections for measurement item appear.
3.
Select [Edge center].
The operations from here are the same as
p.81
Z550
84
Operation Manual
Edge center
Edge level
Scn 0
Image
Detect set
Meas set
Extra set
Meas mode
Output
Scn 0
OUT0:Height
OUT1:
OUT2:
OUT3:
OUT4:
OUT5:
OUT6:
OUT7:
Measrmnt item
Height
Step: 2 pts
Step: 3 pts
Edge position
Width
Edge center
Peak/bottom
Angle
4. 11.
to for the width measurement.
Set
Set