Image Monitor - Omron Z550 Operation Manual

SECTION 2
Basic Operations

Image Monitor

This is the main monitor screen of the Controller. The first time the power supply is turned on
after delivery, this screen is displayed.The Image Monitor screen consists of two displays, the
profile display and the line brightness display. Use the TRIG Key to switch between the displays.
Profile Display
Run
Scn 0
NEAR
FAR
OUT 0
+005.188000
S+ / :Display S+ENT:Adjust
Profile Display
The distribution of height measurements at 1024 points is displayed as a profile.This display
allows keeping track of the height information visually; it is possible to check how the workpiece
in the lines is detected by checking the shape.
• At setting: It is possible to check whether the sensor is positioned within the measurement
range.
• During measurement: It is possible to visually keep track of the detection status and the
position of the workpiece .
Line beam
Measurement
range
Measurement
center
Z550
26
Operation Manual
99.60ms
Sen0
[ 15]
LV
[ 170]
TRIG Key
PEAK
Sen1
[ ]
LV
[ ]
PEAK
Zero's OFF
mm PASS
Sensor
Line 0
Line Brightness Display
Scn 0 Run
NEAR
FAR DARK
OUT 0
+005.188000
S+ / :Display S+ENT:Adjust
Position
Scn 0 Run
NEAR
FAR
Measurement points (Red)
Profile (yellow)
The measured points are displayed.
No point is displayed when the
measurement is in error.
99.60ms
Sen0
[ 15]
LV
[ 170]
PEAK
Sen1
[ ]
LV
[ ]
PEAK
BRIGHT
Zero's OFF
mm PASS
Line 1023
High
99.60ms
Sen0
[ 15]
Height
LV
[ 170]
PEAK
Sen1
[ ]
LV
[ ]
PEAK
Low