Omron Z550 Operation Manual page 23

Screen Structure
The Controller is operated by selecting functions displayed on the screen.Familiarize yourself
with each function before operating the Controller.
Scene Number
There are 16 scenes.
Setting different measurement
conditions for each one allows
easy switching between
different setups.
Cursor Keys
The cursor is moved to the
desired function by pressing
the Up, Down, Left,
and Right keys.
*Mode
Display
Set
Run
Tools
System
Save
Mode (See the table below)
The current operating mode is displayed.
Scn 0 Run
S+ / :Display S+ENT:Adjust
Key Operations
Displays special key combinations at the bottom of the screen
where available. "S" refers to the SHIFT Key. "S + ENT" indicates
that the ENT Key should be pressed while the SHIFT Key is pressed.
Select this to set the measurement conditions.
This mode is used for performing the actual measurement. The measurement
results are output to an external device via the terminal block or the RS-233C
connection.
Select this to check the sensor installation status and save settings and images
in a PC as backup.
This is used to set the system conditions of the Controller. Select this mode to
set communication specifications with external devices.
Select this to save data in the flash memory in the Controller. If new settings
have been made, be sure to save the data before quitting.
Basic Operations
99.60ms
Measurement period
(Sampling time)
It varies depending on the
item to be measured.
Description
SECTION 2
Z550
21
Operation Manual