Omron Z550 Operation Manual page 226

SECTION 6
Communication with External Devices
Timing Chart 3
Measurement mode
Continuous measurement
Hold measurement is started when the measurement result matches with the trigger conditions
during a continuous measurement.
Assuming the measurement duration is specified to three times the measurement time (*1)
Image acquisition
Calculation
processing
Terminal block output (*2)
Analog output
(OUT for which hold is set)
Terminal block output
Analog output
(OUT for which no hold is set)
OFF
GATE output
ON
PROFILE command
(received by Controller)
PROFILE data
(sent by Controller)
RUN output OFF
ON
BUSY output OFF
ON
*1 Specify the measurement duration to 200 ms when the measurement time is 100 ms in order to set it
to three times the measurement time.
*2 ALL-PASS and ERROR outputs are always output at the timing when "hold" is set.
*3 Profile data for which arithmetic processing has been completed when the PROFILE command is
received is transmitted.
Z550
224
Operation Manual
Hold&Logging
Hold (Self)
This result matches with
Measurement time
the trigger condition.
Output value according to the hold setting
GATE
GATE
ON delay
ON time
PROFILE command
PROFILE data
(*3)