Trend Monitor - Omron Z550 Operation Manual

Trend Monitor

It is possible to display a time series of measurement values (up to 30 seconds) as a waveform.
When the measurement timing is entered using an external trigger, the measurement values are
displayed as a time series from the time the trigger is turned on until it is turned off.
Press the TRIG Key to switch between display update and stop.It is also possible to specify the
timing via an external trigger.
Scn 0 Run
Thru
OUT 0
+005.188000
S+ / :Display S+ENT:Adjust
Output number
The current output number is displayed.
Screen Mode
Thru: The waveform obtained by the Sensor is displayed continuously.
Trig: A still image of the waveform based on the trigger settings is displayed.
Thin lines are used to represent the measurement start and
measurement end timings.
If the hold function has been set to [Hold (External)] or [Hold (Self)], the waveform prior to when the
measurement is held is displayed.
If the logging function has been specified, the waveform after the measurement is held is displayed.
Conversion values for X and Y axes
The units corresponding to 1 division (1 div) on the
waveform display are displayed. If the setting is
changed, the display also changes. Use these
values as reference when displaying the waveform.
99.60ms
1div T: 0.996 [s]
V:0.1250[mm]
Zero's OFF
mm PASS
Measurement
Judgment result
value
T:Second(s)
V:Measurement value(mm)
1div
Waveform display status
During waveform display,
(green) is displayed.
While the waveform is stopped,
(red) is displayed.
Trigger waveform
The trigger status is displayed.
Force-zero
Zero's OFF: Force-zero not executed
Zero's ON: Force-zero executed
SECTION 2
Basic Operations
Z550
Operation Manual
31