Omron Z550 Operation Manual page 124

SECTION 3
Setting Measurement Conditions (Expert Menu)
A confirmation message appears.
8.
Select [Execute].
The setting will be registered and the screen display returns to
Setting [Hold (Self)]
A waveform of the workpiece shape can be obtained using the Trend Monitor screen,
and the self trigger level can be set based on this waveform.
1.
Display the Trend Monitor screen.
2.
Display the output to be used as the self trigger.
3.
Let the workpiece go through, and press the TRIG
Key at the instant the waveform representing the
workpiece appears.
.
Z550
122
Operation Manual
The settings
will be changed.
OK?
Execute Cancel Back
1
.
Scn 0 Run