Using The Download Function - Omron Z550 Operation Manual

Using the Download Function

The controller acquires information from the sensor at startup. The startup time can be shortened by
downloading this information into the controller and storing it.
Option
OFF Information is acquired via the sensor connection at startup. The startup time will be longer
(default setting) than when the ON function is used.
ON The information stored inside the controller is acquired at startup. The startup time will be
shortened by comparison to when the OFF function is used.
To replace the sensor for connection to the controller, perform the following procedure:
1.Turn off the download function.
2.Replace the sensor.
3.Download the new sensor information.
4.Turn on the download function.
If the sensor is replaced while the download function is on, measurements cannot be taken correctly with the
new sensor because the old sensor information (such as the measurement range) is still stored.
Also, perform the above procedure when a sensor of the same model is used to replace the existing sensor.
1.
Enter the System mode and select [Environment].
p.174
The setting screen appears.
2.
Change the setting of [Download].
3.
Select [End].
The setting will be registered and the screen display returns to
Meaning
Scn 0 System
Comm
Profile
Environment
Download
Initialize
Version
Scn 0 System
Settings :
Sensor :
Scene : Console
Monitor :
1st scene :
Coordinate : Individual
Dec. pts : 6 digits
Download :
End
1
.
SECTION 5
System Settings
Expert
Mirror
Image
Scn 0
OFF
Z550
181
Operation Manual