Table of Contents
Advertisement
The test measurement screen appears.
4.
Position the workpiece to be tested and press the
ENT Key.
A menu for selecting test methods appears.
5.
Set [Test mode] to [# times].
6.
Make the required setting for [# of samples] and
select [End].
The screen display returns to
7.
Display the output whose measurement value you want to check.
Up/Down key: Switches between outputs.
8.
Press the TRIG Key.
The test measurements are performed for the number of
times set and the measurement results are displayed.
Press the Left/Right key in order to switch between
displays.
9.
To continue testing, repeat the operations of
8
.
10.
To stop the test measurements, press the ESC Key.
The display returns to the Tools mode screen.
4
.
7.
and
Other Functions
Scn 0
Tools
OUT0
-----------mm
No.
NUM
AVE
MAX-MIN
1
2
3
4
5
Scn 0
Tools
-0010.53150mm
OUT0
No.
NUM
AVE
MAX-MIN
1
Test mode
# times
2
# of samples:
[ 100]
3
4
End
5
When measurement starts, the display
changes from [STOP] to [RUN].
During measurement, [RUN] flashes.
Scn 0
Tools
OUT0
-001.81313 mm
No.
NUM
AVE
1
100
-0001.82836
+0000.00367
2
100
-0004.82600
+0000.00305
3
4
5
SECTION 4
[STOP]
[STOP]
[
RUN
]
MAX-MIN
Z550
161
Operation Manual
Advertisement
Table of Contents
Troubleshooting
