Testing Measurement Performance (Test); Test Measurement P - Omron Z550 Operation Manual

Testing Measurement Performance (Test)

Use the following procedure to execute test measurements according to the conditions set for the output
currently displayed.The test measurements are completed internally by the Controller and the
measurement results are not output via the terminal block or RS-232C.
There are two types of measurement methods.
• Test measurements can be performed continuously for the specified number of measurements only.
• The TRIG Key can be used to specify the start and end of the test measurement period.
p
The output number being tested is displayed.
Press the Up and Down keys to change the number.
Measurement results
Scn 0 Tools
OUT0 -0004.03975mm
No. AVE
NUM
1 100 -0004.05122
2 100 -0004.05122
3
4
5
Test results
The most recent test results are displayed in reverse video.
After the 5th measurement, the previous results
are overwritten in order starting from 1.
Meaning of Test Results
Item
NUM
AVE
MAX-MIN
MAX
MIN
The results of five measurements are displayed as a list; it is convenient in the following situations.
• When evaluating the precision of measurement under partially different conditions
• When comparing the steady state and moving state
Measurement status
During measurement, [RUN] flashes.
[STOP]
MAX-MIN
+0000.01821
Switch display items
+0000.01821
Displays the number of measurements performed during the test measurement
period.
Displays the average measurement value for the test measurement period.
Displays the difference in the measurement values (the maximum measurement
value minus the minimum measurement value) for the test measurement period.
Displays the maximum measurement value for the test measurement period.
Displays the minimum measurement value for the test measurement period.
Other Functions
Scn 0 Tools
OUT0 -0004.03975mm
No. MAX
NUM
1 100 -0004.03948
2 100 -0004.03948
3
4
5
Meaning
SECTION 4
[STOP]
MIN
-0004.05770
-0004.05770
Z550
159
Operation Manual