Omron Z550 Operation Manual page 80

SECTION 3
Setting Measurement Conditions (Expert Menu)
Edge Position
The edge position of the workpiece can be measured.
Specify the edge detection level. Edges corresponding to that level will be searched.
The following conditions will be used as an example for describing the setting procedures.
1.
Select [Meas set].
A list of outputs appears.
2.
Select an output for which [Edge position] is set.
In this example, select [OUT1].
The selections for measurement item appear.
3.
Select [Edge position].
Z550
78
Operation Manual
Edge position
Edge level
Scn 0
Image
Detect set
Meas set
Extra set
Meas mode
Output
Scn 0
OUT0:Height
OUT1:
OUT2:
OUT3:
OUT4:
OUT5:
OUT6:
OUT7:
Measrmnt item
Height
Step: 2 pts
Step: 3 pts
Edge position
Width
Edge center
Peak/bottom
Angle
Set
Set