Omron Z550 Operation Manual page 82

SECTION 3
Setting Measurement Conditions (Expert Menu)
Points that can be detected at the specified edge level are
displayed as measurement point candidates.
8.
Repeat pressing the Left or Right key until the cross
cursor appears at the edge to be detected.
In some cases, the cursor will not be displayed on
the intersection point of the edge level and the
edge position. However, selection of an arbitrary
cursor will give the same measurement result (the
intersection point becomes the measurement
point), as long as the selected cursor exists near
the intersection point.
9.
Press the ENT Key to select the setting.
A confirmation message appears.
10.
Select [Execute].
The setting will be registered and the screen display returns to
Z550
80
Operation Manual
Reference will be
registered. OK?
Execute Cancel Back
2
.