Omron Z550 Operation Manual page 227

Timing Chart 4
Measurement mode
Continuous measurement
Measurement values are accumulated and output according to the logging settings during a
continuous measurement. When the hold conditions are specified, the corresponding values are
held, accumulated, and then output.
Assuming the sampling interval is set to three samples
Measurement time
Image acquisition
Calculation processing
Accumulated data
(OUT for which hold is set)
Terminal block output
Analog output
(OUT for which hold is set)
Accumulated data
(OUT for which
no hold is set)
Terminal block output (*1)
Analog output
(OUT for which no hold is set)
OFF
GATE output
ON
(*2)
PROFILE command
(received by Controller)
PROFILE data
(sent by Controller)
RUN output OFF
ON
BUSY output OFF
ON
*1 ALL-PASS and ERROR outputs are always output at the timing when "no hold" is set.
*2 The GATE output does not function at logging.
*3 Profile data for which arithmetic processing has been completed when the PROFILE command is
received is transmitted.
Communication with External Devices
Hold&Logging
Logging
Accumulate values according to the hold setting.
Output value according to the hold setting
Accumulate data once every three measurements
PROFILE command
SECTION 6
PROFILE data (*3)
Z550
Operation Manual
225