Kyocera TASKalfa 7002i Service Manual page 1339

Step Check description
5 Replacing the operation
panel main PWB
F010: Program read error (SSD)
The garbled 2bit data was detected during the program read from the flash memory.
Step Check description
1 (When the service call
error appears after replac-
ing the SSD) Replacing the
SSD along the correct pro-
cedures
2 Checking the SSD (if lit
after replacing the SSD)
3 Resetting the main power
4 Checking the SSD
5 Checking the connection
6 Executing U021
7 Replacing the SSD
Assumed cause
The operation panel main
PWB is faulty.
Assumed cause
The firmware is not stored
in the SSD.
An SSD out of specifica-
tion is installed.
The communication
between the main PWB
and the operation panel
main PWB is faulty.
The SSD is not properly
attached.
The connector is not prop-
erly connected. The wire or
the SATA cable is faulty.
The backup RAM data is
faulty.
The SSD is faulty.
7-479
Measures
Replace the panel main
PWB.
Measures
Insert the USB memory
device containing all released
firmware into the main unit,
and turn the main power on.
Install the SSD matching the
memory capacity specifica-
tion.
Remove the original and
check the sensor. Next, turn
off the power switch and main
switch. Then, turn on the
main switch and power
switch when passing 5 sec-
onds.
Check if the SSD terminal is
not faulty and clean it. Then,
reinstall the SSD.
Clean the terminal of the fol-
lowing SATA cable connector
and the wire connectors and
reconnect the connectors. If
there is no continuity, replace
the SATA cable or the wire. •
Main PWB - Operation panel
main PWB
Execute U021 to initialize the
backup RAM data.
Backup the data in the SSD
at U026. Then, replace the
SSD and turn the main power
on while installing the USB
memory storing the firmware
for the affected model n the
main unit.
2WA/2NJ/2RK
Reference
Detaching
and Reat-
taching the
operation
panel
PWB
Reference
Firmware
Update
Detaching
and Reat-
taching the
SSD
Wiring dia-
gram
Executing
U021
Detaching
and Reat-
taching the
SSD