Kyocera TASKalfa 7002i Service Manual page 1372

U01092/E01092
Step Check description
1 Resending
2 Checking the transmit start
speed
3 Changing the initial value
U01093/E01093
Step Check description
1 Checking the settings
2 Checking the settings
U01094/E01094
Step Check description
1 Resending
2 Checking the transmit start
speed
3 Changing the initial value
Assumed cause
Communication is stopped
since there are impossible
combination of symbol
speed and communication
speed at V.34 sending.
Line condition is poor.
(Destination unit)
Line condition is poor.
(Own machine)
Assumed cause
The modem is not
detected since the
received signal is attenu-
ated with its frequency
response.
The modem is not
detected since the
received signal is attenu-
ated with its frequency
response.
Assumed cause
DCS/NSS signal send
retrial time is exceeded at
phase B during transmis-
sion.
Line condition is poor.
(Destination unit)
Line condition is poor.
(Own machine)
7-512
Measures
Resend.
Execute U630 [TX Speed] to
reduce the transmit start
speed. Then, resend the
data.
Change the default value of
the transmit start speed by
executing U630 [TX Speed].
Measures
Set the modem detection
level at U650 [RX Mdm
Level]. (Initial setting: -
43dBm)
Set the G3 reception cable
equalizer in U650 [Reg G3
RX Eqr]. (Initial setting:
0dBm)
Measures
Resend.
Execute U630 [TX Speed] to
reduce the transmit start
speed. Then, resend the
data.
Change the default value of
the transmit start speed by
executing U630 [TX Speed].
2WA/2NJ/2RK
Reference
U630 Exe-
cution
U630 Exe-
cution
Reference
U650 Exe-
cution
U650 Exe-
cution
Reference
U630 Exe-
cution
U630 Exe-
cution