Table C-8. Supported Keywords For The Port Command - Nortel 2000 Software Reference Manual

Chapter 1 na Commands
Remote Annex Administrator's Guide for UNIX
Book C-18
If you do not identify a specific Annex using the @ symbol and a name
or Internet address when entering the port_set, all Annexes in the current
annex_list are used. A port_set referring to the default annex_list is
updated if a new annex command is issued. The keyword identifies
groups of ports. Table C-8 defines the supported keywords for port.

Table C-8. Supported Keywords for the port Command

Keyword Definition
all Sets default port_set to all serial ports and virtual CLI
connections.
serial Sets default port_set to all serial ports.
The following example defines port 1 on the Annex using the Internet
address 132.245.6.34 as the default port_set:
command: port 1@132.245.6.34
The next example defines ports 1–5 on the same Annex as the default
port_set:
command: port 1–5@132.245.6.34
This example defines all but port 6 on every Annex in the default
annex_ list:
command: port 1–5,7–16
Book C