Nortel 2000 Software Reference Manual page 38

Chapter 1 na Commands
Remote Annex Administrator's Guide for UNIX
Book C-20
If you plan to use LAT or a feature enabled through the option_key
parameter, set the lat_key and option_key parameters manually (using
na or admin) and reboot the Annex before issuing the read command.
The lat_key and option_key parameters are not enabled until you reboot,
and any LAT- or option_key-related parameters in the script file are not
recognized until lat_key or option_key is enabled. Also, make sure the
script file does not contain a different option_key setting; if it does, delete
the setting before issuing a read.
If a script file was written from an Annex that had option_key enabled,
and you are reading the file to an Annex on which option_key has not
been enabled, delete the option_key and all related parameters from the
script file before issuing a read.
The read command loads parameters even if the subsystem
is disabled.
The following sample script file, called testscript, modifies Annex
parameters:
# standard parameters for Annexes on our network
set annex pref_load_addr 132.245.6.63
set annex pref_dump_addr 132.245.6.63
set annex load_broadcast Y
set annex name_server_1 dns
set annex pref_name1_addr 132.245.6.9
set annex host_table_size 30
set annex cli_prompt "%n%s%p%c"
set annex timezone_minuteswest 360
set annex daylight_savings usa
set annex enable_security Y
set annex vcli_security Y
set annex syslog_mask all
set annex syslog_host 132.245.6.9
Use this script as follows:
command: annex thirdfloor,frontlobby,backhall
command: read testscript
Book C