Nortel 2000 Software Reference Manual page 218

Chapter 3 Using the CLI Commands
Remote Annex Administrator's Guide for UNIX
Book C-200
Table C-65. Setting Parameters Using stty (continued)
Parameter Description
lera character Sets the line erase character. The default is
newlin Defines the terminal as a new line terminal, which
–newlin sends a carriage return followed by a line feed when
Return is pressed and displays a carriage return
followed by a line feed when a line feed character is
received. The default is –newlin.
oflow argument Specifies the terminal's method for stopping output
from the Remote Annex. The default is xonoff.
Possible values are:
none No flow control; characters are lost if the buffers
overflow.
eia Selects hardware flow control and works only if the
control_lines parameter is enabled for hardware flow
control and the terminal is wired appropriately.
xonoff Specifies XON/XOFF flow control. When the Remote
Annex receives XOFF, it stops sending output to the
terminal; when it receives XON, it starts sending
output again. Setting ostopc to CTRL-S for XOFF and
ostartc to CTRL-Q for XON allows you to type these
characters to stop and to start output before data scrolls
off the screen.
both Specifies both XON/XOFF and CTS/RTS flow control.
Both flow controls are independent. Data flows out of
the port only if CTS is high and the last received XON/
XOFF character was an XON. Receiving XOFF or
dropping CTS stops output flow from the Remote
Annex to the device.
bell Has the same effect as setting the parameter to none.
(continued on next page)
Book C
CTRL-U .