Nortel 2000 Software Reference Manual page 234

Chapter 3 Using the CLI Commands
Remote Annex Administrator's Guide for UNIX
Book C-216
Entering the tn3270 command puts the Remote Annex in tn3270
command mode and displays the tn3270 prompt:
annex: tn3270
tn3270:
In tn3270 command mode, you can issue the commands shown in
Table C-74 on page A-225.
The tn3270 command is available only if the option_key parameter
is set to the correct value. Each Remote Annex requires a unique
value. Depending on what you requested when you purchased your
Remote Annex, this value may be affixed to the bottom of your
Remote Annex. If it is not, you must obtain a valid value from your
supplier. You will be asked for your Remote Annex's Ethernet
address, which is taped to the back of the unit.
When requesting a tn3270 option_key value from your supplier, be
sure to mention any of the other option_key features currently
enabled for your Remote Annex. To check the status of the options
enabled for your Remote Annex, issue the CLI stats -o command.
ASCII Terminal Requirements and Setup
An ASCII terminal connected to the Remote Annex must have the
following characteristics in order to use tn3270:
• Cursor addressing and movement. If a terminal does not have
this feature, tn3270 denies access to the IBM host and displays
the error message Terminal must have cursor addressing
capability.
• A screen size of at least 24 lines and 80 columns. If the screen is
smaller, tn3270 denies access to the IBM host and displays the
error message Terminal must have at least 24 lines and 80
columns.
Book C