Rip_Sub_Advertise; Routed; Rwhod; Security_Broadcast - Nortel 2000 Software Reference Manual

Book C Chapter 2 Configuration Parameters

rip_sub_advertise

This Interface parameter controls whether or not the Annex advertises
subnet routes over the SLIP, PPP, and Ethernet interfaces. When enabled,
subnet routes are advertised; when disabled, subnet routes are not
advertised. A Y enables this parameter, an N disables it. The default is Y.

routed

This Annex parameter determines whether or not the RIP routing daemon
is enabled. When the daemon is enabled, the Annex performs both active
and passive RIP routing. When the daemon is disabled, no RIP routing
occurs. A Y enables this parameter, an N disables it. The default is Y.

rwhod

This Annex parameter determines whether or not the Annex listens for
RWHO broadcasts when it builds the host table. A Y enables this
parameter, an N disables it. The default is Y.

security_broadcast

This Annex parameter determines whether or not the Annex broadcasts
for security validation if the preferred security servers are not available.
When enabled, the Annex broadcasts for security; when disabled, the
Annex does not broadcast for security. A Y enables this parameter, an N
disables it. The default is Y.
Remote Annex Administrator's Guide for UNIX
Book C-101