Chapter 1
na Commands
Remote Annex Administrator's Guide for UNIX
Book C-12
To copy port 1 parameters to the remaining ports on the same Annex:
command: copy port 1@132.245.6.40 2–16@132.245.6.40
To copy port 1 parameters from one Annex to port 5 on another Annex:
command: copy port 1@frontlobby 5@132.245.6.55
dumpboot
The dumpboot command requires superuser privileges. When the
Annex dumpboots, it terminates all active connections.
The dumpboot command performs a dump of every Annex specified in
the annex_list and then reboots the Annex. You can set the boot time,
and the dumpboot command sends a warning message to users attached
to the Annex. Table C-6 describes the arguments for dumpboot. The
syntax is:
dumpboot [–aq] [[+] [HH:] [MM]] [annex_list] [filename] [warning]
The following is an example of the dumpboot command:
command: dumpboot
annex list (return for default): backhall
filename (return for default): <cr>
warning: Diagnostic testing
The Annex sends the dump to a defined preferred dump host. If that host
is not defined or does not respond, the Annex broadcasts its dump request
and dumps to the first host that responds.
Book C