Nortel 2000 Software Reference Manual page 248

Chapter 3 Using the CLI Commands
Remote Annex Administrator's Guide for UNIX
Book C-230
7. If you plan to use the IBM print-screen function:
• Use na, admin, or an SNMP directive to set the Remote
Annex port parameters printer_host, printer_name, and
user_name for each port that is to use tn3270. Set the first
two parameters as explained in Table C-72 and make sure
that user_name is set to a non-null value.
• Configure the UNIX host specified by printer_host to allow
print requests from the Remote Annex. See the manual pages
for the host's line-printer daemon (lpd).
• If your Remote Annex obtains map3270 from a host that is
running Berkeley UNIX, modify map3270 to include the
ASCII key sequence for the IBM print-screen key (LPRT).
Since the print-screen function is not supported by Berkeley
tn3270, LPRT is not included in Berkeley map3270 files.
8. Make sure that the Remote Annex's name is either listed in the
Remote Annex's host table or available from the Remote
Annex's name server (see hosts on page A-149, name_server_1
on page Book C-79, and name_server_2 on page Book C-79).
9. Use the na command reset to reset the ports configured in Steps
7 and 8 (see reset on page Book C-21 for more details).
Book C