Nortel 2000 Software Reference Manual page 157

Book C
Table C-43. Arguments for the boot Command (continued)
Argument Description
time Defines the time for a shut down as either an offset +MM or
+HH:MM, or a clock time HH:MM.
filename Identifies the name of the file in which the Remote Annex's
image is maintained. If you do not enter a filename, the
Remote Annex prompts for one. If you enter a blank line, the
Remote Annex boots the image defined in the image_name
parameter. Pressing the Return key at the prompt directs the
Remote Annex to boot the default filename.
warning Allows an optional message (up to 249 characters) to be sent to
the users. This prompt appears only if the –q argument is not
specified.
The following command line requests that the Remote Annex reboot an
hour and fifteen minutes from the time of entry:
annex# boot +1:15
bootfile: <cr>
warning: Shutting down for PM
The Remote Annex can request its boot file from a defined preferred load
host. If that host is not defined, or does not respond, the Remote Annex
broadcasts its request and boots from the first load host to respond
(assuming the load_broadcast parameter is set to Y).
Booting the Remote Annex with a non-existent image filename
causes the unit to hang as it searches for the image. Pressing the Reset
switch recovers from this condition.
Remote Annex Administrator's Guide for UNIX
Chapter 3 Using the CLI Commands
Book C-139