Ps_History_Buffer; Redisplay_Line; Remote_Address; Reset_Idle_Time_On - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters Book C

ps_history_buffer

This asynchronous port parameter is used with the telnet command to
indicate how much incoming data to buffer on a slave port. Incoming data
is buffered continuously before, during, and after the Telnet session; no
data buffering occurs during LAT access to the port. The port must be
reset after setting or changing this value. Values range from 0 to 32767.
The default is 0 (disabled).

redisplay_line

This asynchronous port parameter defines the reprint line character for
CLI users. The allowable value is a control character sequence. The
default is .
CTRL-R (^R)

remote_address

This asynchronous port parameter defines the IP address for a host at the
other end of the asynchronous line. This parameter works whenever SLIP
or PPP is in effect for the port (for example, because the mode parameter
is set to slip or ppp, or because the mode is set to auto_detect and SLIP
or PPP is detected). The default is 0.0.0.0.

reset_idle_time_on

This asynchronous port parameter defines whether input or output resets
the idle timer. The idle time is the time lapse between activity and
inactivity at the device. This parameter is used with the who command.
Valid options are input and output. The default is input.
Remote Annex Administrator's Guide for UNIX
Book C-96