Nortel 2000 Software Reference Manual page 274

Chapter 5 Software Reference Guide
Remote Annex Administrator's Guide for UNIX
Book C-256
Parameter Values
hardware_tabs Y or N
(asynchronous)
hardware_tabs Y or N
(parallel port)
host_table_size 1–255,
(255=unlimited,
254=none)
image_name host file name
(up to 100
characters)
imask_7bits Y or N
inactivity_timer 0–255
inet_addr Internet address
input_flow_ eia, start/stop,
control bell, none
Default Description
Y Allows the terminal
to expand ASCII tab
characters if the
terminal does not
support hardware
tabs.
N Enables/disables
use of hardware tab
stops for parallel
printers.
64 Sets the maximum
number of entries in
the host table.
"" Specifies the name
of the file
containing the
Annex's operational
code.
N When enabled, the
Annex port ignores
the eighth bit of
received characters.
0 (off) Specifies the
amount of time, in
minutes, a port can
remain inactive
before all sessions
are terminated and
the port reset.
no default Sets the Annex's
Internet address.
bell Specifies the
method of flow
control for input
received from device
connected to serial
port.
Book C