Config_File; Connect_Security; Control_Lines; Table C-22. Valid Options For The Control_Lines Parameter - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters
Remote Annex Administrator's Guide for UNIX
Book C-54
config_file
This Annex parameter defines the file name for the configuration file
maintained on the load host. This file contains information about
gateways, rotaries, macros, and services; it must reside in the directory /
usr/spool/erpcd/bfs. The default file name is config.annex.

connect_security

This asynchronous port parameter enables the host-based security policy
for access from the CLI to the network (using telnet and rlogin only). If
connect_security is enabled, the user must receive authorization to
connect to a host on the network. The supplied security policy scans the
file /install-directory/acp_restrict to authorize a connection to a host
from the Annex. If authorization is not granted, the connection is not
made. A Y enables this parameter, an N disables it. The default is N.

control_lines

This asynchronous port parameter defines the type of hardware control
lines used on this port. Table C-22 describes the valid options; the default
is none.

Table C-22. Valid Options for the control_lines Parameter

Option Description
both Allows both flow control and modem control.
flow_control Configures the control lines for flow control (RTS/
CTS), but does not activate hardware flow control.
modem_control Configures the control line for modem control using
DTR/DCD/DSR hand-shaking.
none Does not implement hardware control lines.
Book C