Nortel 2000 Software Reference Manual page 231

Book C
Table C-70. Issuing Commands Using telnet (continued)
Command
crlf
crmod
localchars
(continued on next page)
Remote Annex Administrator's Guide for UNIX
Chapter 3
Description
Toggles carriage return-line feed mode.When
enabled, a carriage return received from the serial
port is encoded as a Telnet protocol carriage
return-line feed end-of-line sequence. When
disabled, a carriage return received is encoded as a
Telnet protocol carriage return-null carriage-return
sequence.
Additionally, when using the –r flag, enabling this
mode causes the Telnet encoder to send a carriage
return-line feed for areceived carriage return and to
delete a subsequent line feed from the input stream
if it is the next received character. When disabled,
all characters received are sent without this
translation.
Toggles carriage return mode. When enabled, most
carriage return characters received from the host are
translated into a carriage return followed by a line
feed. This mode is used when the host sends only a
carriage return without a line feed. The initial value
disables carriage return mode.
Toggles the local recognition of Telnet special
characters. When enabled, the special characters are
recognized by the Remote Annex and are mapped
into appropriate Telnet control sequences. The
initial setting is will map when the mode is
line-by-line, and won't map when the mode is
character-at-a-time. You can toggle the localchars
between will map for both modes, won't map for
both modes, and the initial setting of will/won't
translate based on mode.
Using the CLI Commands
Book C-213