Book C
slip_ppp_security
This asynchronous port parameter controls dial-up SLIP/PPP access.
When this parameter and the enable_security parameter are enabled, the
Annex determines whether or not the user at the CLI is authorized to
execute a slip or ppp commmand. A Y enables this parameter, an N
disables it. The default is N.
slip_tos
This asynchronous port parameter allows an Annex to send interactive
traffic (telnet, rlogin, and ftp control sessions) before sending any other
traffic. This parameter provides a type-of-service based SLIP queuing. A
Y enables this parameter, an N disables it. The default is N.
speed
This asynchronous port parameter defines the baud rate of the
asynchronous line between the device and an Annex. The value entered
in this parameter must match the device's baud rate. Allowable values
are autobaud, 50, 75, 110, 134.5, 150, 200, 300, 600, 1200, 1800, 2000,
2400, 3600, 4800, 7200, 9600, 19200, 38400, 57600, and115,200. The
default is 9600.
If you want the line speed to be determined automatically, use the
autobaud parameter. If you set autobaud to N, you must enter a
value in speed.
Not all Annexes support all port speeds (see your Annex hardware
guide for detailed information).
Remote Annex Administrator's Guide for UNIX
Chapter 2
Configuration Parameters
Book C-105