Cli_Inactivity; Cli_Interface; Cli_Prompt - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters Book C

cli_inactivity

This asynchronous port parameter specifies the amount of time in minutes
that the Annex remains idle before disconnecting a CLI session from a
port. Unlike the inactivity_timer, this timer does not disconnect a CLI
session with active jobs. Allowable values range from 0 (or off) to 255
minutes or immediate. The default is 0.
Entering 0 disables the timer; entering 255 causes the Annex to disconnect
as soon as it exits from its last job. Entering immediate causes the Annex
to hang up the port immediately after exiting the last job.

cli_interface

This asynchronous port parameter allows you to control the prompt that
appears for VMS or UNIX environments. Allowable values are vci and
uci. The default is uci.
When set to vci, the Local> prompt is displayed followed by the
Username> prompt; the uci setting provides a standard UNIX interface
(with prompts defined by the cli_prompt and prompt parameters).

cli_prompt

This Annex parameter defines the Annex prompt for all CLI users. This
parameter uses formatting codes consisting of the percent character (%)
and a single lowercase letter. You can combine up to 16 of these codes
(e.g., %a%c). You can also enter text that will appear in the prompt as
long as the entry as a whole does not exceed 32 characters. The default
prompt is %a%c (the string annex:). Table C-21 lists the formatting
codes.
Remote Annex Administrator's Guide for UNIX
Book C-52