Tni_Esf_Fdl; Tni_Framing; Tni_Line_Buildout; Tni_Line_Code - Nortel 2000 Software Reference Manual

Nortel remote annex 2000 server: reference guide
Hide thumbs Also See for 2000:
Table of Contents

Advertisement

Book C
Chapter 2
Configuration Parameters

tni_esf_fdl

This T1 parameter sets the T1 facilities data link (FDL) format. The FDL
format is used in conjunction with the ESF format and determined by the
service provider. The parameter settings include ANSI (ANSI T1.403)
and AT&T (AT&T TR54016) standard formats. The default value is ATT.

tni_framing

This T1 parameter controls which super frame format is used on the
T1 Network Interface. Parameter settings include d4 (super frame) and
esf (extended superf frame). The default setting is esf. The value for
tni_framing may or may not be the same as tdi_framing.

tni_line_buildout

This T1 parameter sets the Line Build-Out (LBO) value. The Channel
Service Unit (CSU) portion of the T1 Network Interface requires the
administrator to configure a LBO value. The service provider will supply
a value measured in decibels (dB) based on the amount of cable loss from
the service provider's location to the Annex. Parameter settings include
0, 7.5, 15, and 22.5. The default is 0.

tni_line_code

This T1 parameter selects the line code for the T1 Network Interface. The
service provider determines the line code setting. Parameter settings
include ami and b8Zs. The default setting is b8zs.
Remote Annex Administrator's Guide for UNIX
Book C-115

Advertisement

Table of Contents
loading

This manual is also suitable for:

4000539061005391

Table of Contents