Name_Server_1; Name_Server_2; Nameserver_Broadcast; Need_Dsr - Nortel 2000 Software Reference Manual

Book C Chapter 2 Configuration Parameters

name_server_1

This Annex parameter defines the type of name service used with the
primary name server. When using this parameter, you must specify a host
using the pref_name1_addr. The options are dns, ien_116, or none. The
default is none.

name_server_2

This Annex parameter defines the type of name service used with the
secondary name server. The service type specified with this parameter is
queried if the type specified with name_server_1 is not available. When
using this parameter, you must specify a host using pref_name2_addr.
The options are dns, ien_116, or none. The default is none.

nameserver_broadcast

This Annex parameter defines whether or not the Annex broadcasts a
name server request if the preferred name servers do not respond. A Y
enables this parameter, an N disables it. The default is N.

need_dsr

This asynchronous port parameter allows an Annex to use the DSR (Data
Set Ready) signal to determine whether a device is attached to the
corresponding asynchronous line. The Annex will not allow connection
to a slave port and will not activate the CLI until the DSR signal is active.
If DSR is deactivated, the connection to a slave line is terminated and the
CLI is deactivated.
Remote Annex Administrator's Guide for UNIX
Book C-79