Nortel 2000 Software Reference Manual page 197

Book C
Table C-59. Arguments for the Superuser route Command (continued)
Argument Description
default Specifies the default route.
In general, using route to add or delete a default
route can have unpredictable results. The only time
you can safely use route to add a default route is
when a default route is not defined in the
configuration file and the Remote Annex is not
receiving
dest Specifies the destination address of the route.
mask Specifies the subnet mask to apply to the destination address.
gateway Specifies the IP address of the gateway (router) that is to be the
next hop for the route. This address must be on a network
directly attached to the Remote Annex.
metric Specifies the number of hops to the destination. Values range
from 1 through 15; the default is 1.
delete Deletes a route (temporary, hardwired, or interface) from the
route cache and the routing table.
Remote Annex Administrator's Guide for UNIX
Chapter 3 Using the CLI Commands
Book C-179