Nortel 2000 Software Reference Manual page 204

Chapter 3 Using the CLI Commands
Remote Annex Administrator's Guide for UNIX
Book C-186
Memory:
total=5242880 avail=3894424 free=2073480 min free=1782488
fails=0
annex:
If the Remote Annex is operating without IP protocols (i.e.,
inet_addr parameter set to 255.255.255.255), the stats command
omits the Inet addr and Subnet mask fields as well as the Broadcast
addr field from the display.
If the Remote Annex is operating without IP on the Ethernet interface,
but IP protocols are enabled (i.e., the subnet_mask parameter is set to
255.255.2555.255), the stats command shows <unused> in place of
the subnet mask value and omits the Broadcast addr field from the
display.
The stats –s command displays statistics for all serial ports:
annex01# stats –s
P# Control Lines Speed CharTx CharRx ParityOverrunFraming
1 none
2 CTS RTS
:
total
The stats –m command displays statistics for active control lines, but
displays the modem controls for all active and inactive control lines rather
than displaying idle.
annex01# stats –m
P# Control Speed CharTx CharRx Parity Overrun Framing
Lines
1 CTS RTS DTR 9600
DCD DSR
2 CTS TRS DTR 9600
DCD DSR
:
64 cts RTS DTR 9600
dcd dsr
38400 2550
4800 2550
111883711987 0
0 0 0
0 0 0
0 0 0
Book C
0 0 0
0 0 0
0 0
0 0
0 0
0 0