Dedicated_Port; Default_Zone_List; Default_Session_Mode - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters
Remote Annex Administrator's Guide for UNIX
Book C-56

dedicated_port

This asynchronous port parameter selects the application name or TCP
port number to which this port can connect. The options are telnet, rlogin,
call, or a TCP port number. The default is telnet.
If port 5B (rlogin) is selected, the Annex uses BSD rlogin. If a port in
the 7000 to 7999 range is selected, the Annex uses TCP. Otherwise,
the Annex uses telnet.
For more details on configuring the Annex for use with dedicated ports,
see Dedicated Ports on page A-62.

default_zone_list

This Annex parameter contains the zone list that is sent to AppleTalk
clients in case of an ACP failure. The string size ranges from 1 to 100
characters. You must use spaces to separate zone names (e.g., general
engineering lab). To escape embedded spaces within a zone name, use
the backslash (\) character. If you do not set this parameter, the Annex
provides the network zone list. The default is a null string ("").

default_session_mode

This asynchronous port parameter defines the default session mode when
the VMS interface is configured (i.e., when cli_interface is set to vci).
Valid options are interactive, passthru, passall, or transparent. The
default is interactive.
Book C