Nortel 2000 Software Reference Manual page 320

Chapter 5 Software Reference Guide
Parameter
forward_key
forwarding_count
forwarding_timer
hardware_tabs
(asynchronous)
imask_7bits
inactivity_timer
input_buffer_size
input_flow_control
input_is_activity
input_start_char
input_stop_char
Remote Annex Administrator's Guide for UNIX
Book C-302
Values Default
vcli: one " "
printable or
control
character.
non-vcli:
string (1 to
16 characters)
0–255 0
0–255, off 0
Y or N Y
Y or N N
0–255 off
(0 = off)
1–255 1
eia, start/ bell
stop, bell,
none
Y or N Y
control char. ^Q
sequence
control char. ^S
sequence
Description
Reopens the next available
higher numbered session
already established at your port.
When set, the port will not
forward received characters
until it receives the specified
number of characters.
Sets the amount of time, in tens
of milliseconds, that will elapse
before forwarding received data.
Allows the terminal to expand
ASCII tab characters if the
terminal does not support
hardware tabs.
When enabled, the Annex port
ignores the eighth bit of received
characters.
Specifies the amount of time, in
minutes, a port can remain
inactive before all sessions are
terminated and the port is reset.
Allocates, in 512-byte blocks,
amount of per-port memory.
Specifies the method of flow
control for input received from
device connected to serial port.
Defines activity as input.
Defines the control character
sequence that restarts input.
Defines the control character
sequence that stops input.
Book C