Book C
Table C-65. Setting Parameters Using stty (continued)
Parameter
Description
imask7
Enables clearing the eighth bit of received characters.
–imask7
This parameter has no effect on transmitted characters.
When the parameter data_bits is set to 5, 6, or 7, imask7
has no effect at all. Setting –imask7 does not clear the
eighth bit. The default is –imask7.
ilower
Controls case conversion for characters sent from the
–ilower
terminal to the Remote Annex. Use ilower for older
terminals without lower case characters. The Remote
Annex converts typed upper case characters to lower
case. The default, –ilower, does not change case.
ixany
Specifies that typing any character restarts the output to
–ixany
the screen that was stopped with the XOFF character.
The default is –ixany.
lbreak
Defines a long break as an attention signal;
–lbreak
–lbreak turns off long break as an attention signal. The
default is lbreak.
ldisp character
Sets the reprint line character. The default is
ixany
Specifies that typing any character restarts the output to
–ixany
the screen that was stopped with the XOFF character.
The default is –ixany.
lbreak
Defines a long break as an attention signal;
–lbreak
–lbreak turns off long break as an attention signal. The
default is lbreak.
ldisp character
Sets the reprint line character. The default is
(continued on next page)
Remote Annex Administrator's Guide for UNIX
Chapter 3
Using the CLI Commands
CTRL-R
CTRL-R
.
.
Book C-199