Setting Parameters To Supplied Defaults - Nortel 2000 Software Reference Manual

Book C
Setting Annex
Parameters
Setting Interface
Parameters
Setting T1
Parameters

Setting Parameters to Supplied Defaults

Each configuration parameter, except the Annex's IP address, has a
default value. Using the na command set, you can return any parameter
to its default setting (for more details, see set on page Book C-24).
Depending on the parameter type, the syntax options are:
1. set annex annex_parameter 0
The set annex annex_parameter 0 command sets parameters that
require a numeric value. For example, to set pref _ dump _ addr to its
default, 0.0.0.0, enter:
command: set annex pref_dump_addr 0
2. set annex annex_parameter ""
The set annex annex_parameter "" command sets all parameters
that require a string value; these parameters default to either a null
string ("") or "<unset>". For example, to set image _ name to its
default, a null string (""), enter:
command: set annex image_name ""
set annex annex_parameter default
3.
The set annex annex_parameter default command sets all other
parameters. These parameters are set by choosing either an option
from a known list or a yes/no response. For example, to set
enable_security to its default, N, enter:
command: set annex enable_security default
To set an interface parameter to its default value, use the set interface
command:
1. set interface [ =interface_set ] interface_parameter ^@
2. set interface [ =interface_set ] interface_parameter " "
3. set interface [ =interface_set ] interface_parameter default
1. set t1 t1_parameters
Remote Annex Administrator's Guide for UNIX
Chapter 2 Configuration Parameters
Book C-35