Autodetect_Timeout; Backward_Key; Banner - Nortel 2000 Software Reference Manual

Chapter 2 Configuration Parameters Book C

autodetect_timeout

This Annex parameter specifies the maximum amount of time the Annex
should wait for auto_detect mode to identify an incoming call as PPP. If
the specified number of seconds is exceeded, or if the user enters a carriage
return before the call is detected as PPP, the Annex places the user in CLI
mode. Valid values for the parameter are 1 - 60; the default value is 30.

backward_key

This asynchronous port parameter specifies a character or string that
reopens the next lower numbered session (already established at your
port) from within the current session without returning to local mode.
When defining this value, use a unique, unused character (such as Control
B) or a string of characters. To clear an existing setting, enter a null string
(""). The default is no control character sequence.
On virtual (telnet) ports, the backward_key value is limited to one
printable or Control character. If the user tries to set this value to more
than one character, i.e., a string, the setting is ignored and the previous
value is restored.
On non-virtual ports, a backward_key string can range from 1 to 16
characters.

banner

This asynchronous port parameter controls whether or not the Annex
banner and message-of-the-day display on CLI ports. A Y enables this
parameter, an N disables it. The default is Y.
This parameter has effect only at the CLI level.
Remote Annex Administrator's Guide for UNIX
Book C-48