Wait - HP 64746 User Manual

Chapter 12: Emulator/Analyzer Interface Commands

wait

wait
This command allows you to present delays to the system.
The wait command can be an enhancement to a command file, or to normal
operation at the main emulation level. Delays allow the emulation system and
target processor time to reach a certain condition or state before executing the next
emulation command.
The wait command does not appear on the softkey labels. You must type the wait
command into the keyboard. After you type wait, the command parameters will be
accessible through the softkeys.
The system will pause until it receives a <CTRL>c signal.
Note that if set intr <CTRL>c was not executed on your system, <CTRL>c
normally defaults to the backspace key. See your UNIX system administrator for
more details regarding keyboard definitions.
The parameters are as follows:
measurement
This causes the system to pause until a pending measurement completes (a trace
_complete data upload process completes), or until a <CTRL>c signal is received. If a
measurement is not in progress, the wait command will complete immediately.
or
This causes the system to wait for a <CTRL>c signal or for a pending measurement
to complete. Whichever occurs first will satisfy the condition.
476