Table of Contents
Advertisement
RANGE
The RANGE parameter allows you to specify a condition for the trace
measurement, made up of one or more values.
The range option can be used for state qualifier labels. Range can only be used
once in a trace measurement.
Refer to the "Qualifying Trigger and Store Conditions" section in the "Using the
Emulation Analyzer" chapter for a list of the predefined values that can be assigned
to the status state qualifiers.
Expression types are "address" when none is chosen.
The parameters are as follows:
address
The value following this softkey is searched for on the lines that monitor the
emulation processor's address bus.
data
The value following this softkey is searched for on the lines that monitor the
emulation processor's data bus.
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying an address, data, status, or executed address value. See the
EXPR syntax diagram for details.
<external_label>
This represents a defined external analyzer label.
Chapter 12: Emulator/Analyzer Interface Commands
RANGE
393
Advertisement
Table of Contents
