Porsche 928 Workshop Manual page 122

928 Engine, Crankcase
10
3. Lower the engine onto the hydraulic
mounts. Detach lifting bar and workshop
hoist.
4. Use a car jack to raise the clutch housing
and transaxle and bring the engine to its in-
stallation position.
Note
To avoid placing the driver plate of the fly-
wheel under strain, start by fitting the driver
plate to the flywheel using the six bolts and
only tighten the pan-head screw of the clamp-
ing sleeve afterwards.
Tightening torque: 80 Nm
5. Top up coolant level to lip. Set heater lever
to "warm".
6. Run the engine until it reaches its operating
temperature, check engine oil and coolant
levels, top up if necessary. The coolant
level should lie near the middle of the ex-
pansion tank.
7. Fill hydraulic steering fluid reservoir and
bleed the steering system.
8. Top up the ATF in the transmission
a
Engine, removlng and replaclng
IO-21
Printed in Germany-XXIX, 1992