Porsche 928 Workshop Manual page 111

928 Engine,
Crankcase
10
52. Unscrew top engine block/clutch housing
mounting bolts.
53. Pull engine forward carefully and Iemove
central shaft I with guide tube.
54. Lift out engine.
Installing
Note the following for installation.
1. Tighten nuts and bolts to specified torques.
2. Add coolant until level is at edge of filler
opening (position-heater lever at "warm").
3. Run engine to operating temperature and
check coolant level. adding mope coolant
if necessary.
Coolant level must reach
center
of expansion
tank.
Printed in Germany
Removing and Installing Engine
10 -9