Table of Contents
Advertisement
70–20
WINDSHIELD/WINDOWGLASS/MIRROR
Backside
a
a
b
b
c
c
a – a
Primer G
b – b
Primer G
c – c
Primer G
Backside
A
A
B
B
C
C
A – A
B – B
C – C
a
b
AVENSIS REPAIR MANUAL (RM1018E)
(d)
HINT:
If an area other than that specified is coated by accident, wipe
off the primer with a clean shop rag before it dries.
NOTICE:
Y
Y
B67034
(e)
HINT:
After cutting off the tip, use all adhesive within the time de-
scribed in the table below.
c
a
b
c
a
b
a
b
B67035
(f)
NOTICE:
Y
Y
Y
BO2821
http://vnx.su
–
WINDSHIELD GLASS
Using a brush or sponge, coat the edge of the glass and
the contact surface with Primer G.
Allow the primer coating to dry for 3 minutes or more.
Do not keep any of the opened Primer G for later use.
Apply adhesive.
Adhesive: Part No. 08850–00801 or equivalent
(1)
Cut off the tip of the cartridge nozzle, as shown in
the illustration.
Tackfree time:
Temperature
35_C (95_F)
20_C (68_F)
5_C (41_F)
(2)
Load the sealer gun with the cartridge.
(3)
Coat the glass with adhesive, as shown in the il-
lustration.
Standard dimension:
a
b
c
Install the glass to the body.
(1)
Using a suction cup, position the glass so that the
reference marks are aligned, and press it in gently
along the rim.
Allow the primer coating to dry for 3 minutes or more.
Check that the stoppers are attached to the vehicle
body correctly.
Check the clearance between the vehicle body and
glass.
Tackfree Time
15 minutes
1 hour 40 minutes
8 hours
12.5 mm (0.492 in.)
8.0 mm (0.315 in.)
3.0 mm (0.118 in.)
Advertisement
Table of Contents
