Mds For Flexible Memory Configuration - Siemens SINUMERIK 840C Installation Instructions Manual

07.97
6.10

MDs for flexible memory configuration

60000
Default value
256 KB
With the introduction of this MD it is no longer necessary to define the UMS size in the
configuration file in the MMC master control.
The upper input limit depends on the NCK memory capacity (4 or 8 MB memory).
Zero means no UMS (see functional description of "Flexible memory configuration").
60001
Default value
704 KB
The upper input limit depends on the NCK memory capacity (4 or 8 MB memory).
60002
Default value
4 000
Zero means no IKA points.
60003
Default value
0
If an area of the memory is reserved for MSD drive software, 194 KB memory is occupied.
Zero means no memory.
The memory is only required for digital drives. The software only loads the MSD software if the
memory has been reserved for it.
Note:
The meaning of this machine data changes as from SW 6.
_______
1) As from SW 4
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Size of UMS memory
Lower input limit Upper input limit
960 or 2 760 KB
0
2 760 KB (as from
Size of part program memory
Lower input limit Upper input limit
960 or 2 760 KB
8
4 920 KB (as from
Number of IKA points
Lower input limit Upper input limit
0
0
Memory for drive software MSD
Lower input limit Upper input limit
0
6FC5197- AA50
6.10 MDs for flexible memory configuration
1)
Units
4 KB/8 KB
SW 4.4)
1)
Units
4 KB
SW 4.4)
1)
Units
65 535 1 IKA point
1)
Units
1
Active
after SK
"Reconfigure
memory"
Active
after SK
"Reconfigure
memory"
Active
after SK
"Reconfigure
memory"
Active
after SK
"Reconfigure
memory"
–
6–211