Siemens SINUMERIK 840C Installation Instructions Manual page 222

07.97
200*
1st measuring system connection (as from SW 3)
Default value Lower input limit
0
Digit No. 7
0
Example for structure
of a value in
MD 200*
Logical
drive no.
(611-D)
Digit No. 1, 0: Local axis number
The control automatically enters the local number of the axis here.
Digit No. 3, 2: Code digital drive
Code 10(-15) assigns the address to 611-D (611-D servo loop or digital setpoint channel).
Codes 1-9, 11-15 are reserved for expansions in the future and are interpreted as for 00 or 10.
The code must be entered by the user.
Digit No. 5, 4: SPC/HMS setpoint output
Permissible values for digital drives are the values 01 and 02:
01: PCU slot 1 (for MSD permanent indirect measuring system)
02: PCU slot 2 (free direct or indirect measuring system)
Digit No. 7, 6: Logical drive number / Servo loop module number
The logical drive number is entered here for digital drives.
Input range (00..15):
Input range (00..30):
(SW 5 and higher)
Notes:
• See Section 5, Machine Data Dialog, for the servo loop assignment.
• Up to SW 4: Only 14 real axes can be defined with a fictitious axis.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Upper input limit
15021015 (up to SW 4)
+0
30021030 (as from SW 5)
6 5 4 3 2
1 0 1 1 0
No. of 611-D Code
servo loop digital
connection drive
00: No submodule available
01..15: According to logical drive number
For more detailed information see MDD
00: No submodule available
01..30: Logical drive number
6FC5197- AA50
6.4 Axis-specific MD 1 (axial data 1)
1 0
0 0
Axis number of servo loop module
(entered by the control)
Active on
Power On
Units
–
6–37